The anti-collision barrier molds can be assembled, and the formwork are connected by bolts. During assembly, pay attention to the assembly sequence of the formwork, and if the model of parts used for connection does not meet the specifications, the tightness of the cast-in-situ anti-collision barrier mold will not meet the use standard, and slurry leakage will occur after pouring concrete, It will seriously or affect the effect of concrete forming and the quality of the mold. Therefore, if the specification of the bolt is not suitable and the wear is serious, it should be replaced in time. The assembly link is very important. The correct assembly method can play a role with the safe production of the mold and protect the mold to a certain extent, The mold not only has the specified step requirements for installation and production, but also has rigid requirements for storage. The steel mold cannot be stored in a humid environment for a long time. The humid environment may cause the mold to rust, which is not only troublesome to clean up, but also may make the service life of the cast-in-situ anti-collision guardrail mold fail to meet the expected standard, Therefore, the dry and ventilated environment is compared with the storage of molds.
The anti-collision barrier mold is also the structural feature of the anti-collision wall components. In order to ensure the accuracy of the mold in the production of anti-collision wall components, the drawings of the anti-collision wall steel mold are often required, which can not only ensure the smooth production, but also ensure the timeliness of processing, killing two birds with one stone. Most of the anti-collision guardrail molds are connected by steel plates. Different molds of bridge guardrails have different lengths and different thicknesses of steel plates. The better things are used, the longer the service life of natural molds will be, and each set of molds can be reused, which responds to the environmental protection policy put forward by our country. Most of the protective walls are concrete or cement, because the finished products made of these two raw materials are relatively strong and durable. The purpose of the anti-collision barrier mold is to reduce the impact pressure, which naturally requires very strong materials. No matter when storing the mold or cement concrete, they should avoid touching water, which will reduce their own advantageous characteristics, can not bring good results and can not meet the specifications of use.